Samsung Galaxy A10 SM-A105G Stock Firmware Download

Today we are going to show you how to install stock firmware on Samsung Galaxy A10 SM-A105G. So let’s get started 

Galaxy A10 SM-A105G Stock Firmware Flashing Tutorial

Before we begin make sure:

• To charge Samsung Galaxy A10 to at least 30%.
• Install Samsung Android USB Driver – Click Here To Download.
• This Firmware Install guide is only for Galaxy A10 SM-A105G only, do not try this on any other device.

Download Samsung Galaxy A10 SM-A105G Stock Firmware

Click Here to Download Galaxy A10 Firmware File

File Size: 2.4 Gb
Android Version: 9
PDA Version: A105GDXU1ASD1
Modem: A105GDXU1ASD1

---

Samsung Galaxy A10 SM-A105G Stock Firmware Install Instructions

1: Download Odin Flash Tool to install stock firmware on Samsung Galaxy A10 SM-A105G.

Click Here to Download Odin Flash Tool

2: Now Extract the Galaxy A10 SM-A105G firmware file using Winrar software or you can choose 7zip also as shown below:

3: Similarly Extract the Odin Flash Tool zip file also

4: Power off your Samsung Galaxy A10 SM-A105G and wait 5-10 seconds until it completely turned off.

5: Once Galaxy A10 SM-A105G is completely turned off , boot it into Download Mode:

• First Press and Hold Power Button.
• Now While Holding Power Button, Press and Hold Volume Down button. Keep Holding both the buttons until you see a warning screen.

6: Now Press Volume Up Button to continue.

7: Connect your Galaxy A10 SM-A105G to computer with the help of USB Cable.

8: Now Run Odin3 v3.13.1 file as shown below:

9: Connect Galaxy A10 to computer, Once Connected Odin will display a ADDED message as shown below:

10: Load the Galaxy A10 SM-A105G firmware files in Odin:

• Click on AP Button and browse to the Galaxy A10 SM-A105G Stock Firmware Folder and load the file with the name AP in its starting.
• Similarly Load the BL, CP and CSC file.

Note: Select CSC file is you want to do a clean install or you can Select Home_CSC if you want to keep your apps and data.

11: Once all the files is loaded in Odin click on START Button to begin installing stock firmware on Galaxy A10.

12: Now wait for the Odin to complete the installation, it will normally takes 2-15 Minutes to complete the flashing process.

13: Once the installation is completed Odin will show Pass/ Reset message.

That’s it. You have successfully installed Stock firmware on Galaxy A10 SM-A105G :D.

---

Quick Help and Solutions to some of the basic flashing problems:

1:Unable to Boot into Download Mode, then Try this keys combo:
1: POWER + VOLUME DOWN 
2: POWER + VOLUME DOWN + BIXBY
3: VOLUME DOWN + VOLUME UP than USB cable
4: POWER + VOLUME DOWN + VOLUME UP
5: POWER + VOLUME DOWN + HOME BUTTON
6: (Note9) USB cable + VOLUME DOWN + BIXBY

2: Odin show you Fail message instead of Pass/ Reset, then you need to follow the instructions again from step 4.

3: If Odin unable to connect with your device or it you are unable to see the added message, then you need to install Samsung Android USB driver to install this problem.

4: Odin Stuck at setup connection message i will recommend you to wait 15 minutes, if still it was unable to recover, then you need to follow the procedure again.